CAD WX1000HH User Guide & Wireless Setup

CAD Audio · Wireless systems

Find a channel, pair the handheld with the receiver, and choose the right output for your mixer.

Sources checked November 20, 2026

CAD WX1000HH handheld transmitter beside its receiver

Official manufacturer documents

WX1000HH user guide

English PDF · 4 spreads

Revision 00, marked 0822. Receiver controls, transmitter pairing and output connections. The PDF pairs two printed pages on each sheet.

PAC setup help

Scan at the receiver

Use the receiver’s automatic frequency scan before pairing the handheld. If the controls do not respond, check the lock symbol and the lock/unlock diagram on the same spread.

Receiver operating instructions, PDF sheet 3

Pair over infrared

Briefly press the receiver’s center SET button. Bring the transmitter close to the infrared indicator on the left of the receiver panel. CAD specifies about 2 inches (5 cm).

Pairing instructions, PDF sheet 3

Trace the signal to the mixer

Check the receiver’s RF and AF indicators while speaking. Then trace the audio cable from the receiver’s balanced XLR or unbalanced quarter-inch output to the mixer channel you are monitoring.

RX1000 front and rear panels, PDF sheet 4

Shop options

Sennheiser XSW 1-825-A handheld system

A complete single-handheld system for vocals. It has its own A-band transmitter and receiver and should be used as a matched set.

View alternative at PAC

CAD Audio WX1000HH UHF Wireless Handheld Microphone System

Reference listing for the CAD receiver and handheld pictured above.

View CAD WX1000HH at PAC