Sennheiser XSW 1 A-Band Wireless Microphone System Manuals

Sennheiser · Wireless microphones

Choose the guide that matches your receiver. The headset and single-handheld kits use the EM-XSW 1. The two-handheld kit uses the EM-XSW 1 DUAL, with separate controls for each channel.

Sennheiser XSW 1-ME3-A headset, bodypack transmitter and single-channel receiver
XSW 1-ME3-A headset system shown.

Official manufacturer documents

XS Wireless 1 & XS Wireless 2 instruction manual

English · 90 pages · v1.1, May 2026

Use the EM-XSW 1 or EM-XSW 1 DUAL chapter for the receiver in your kit.

XS Wireless 1 illustrated quick guide

Multilingual with English · 2 pages · 571312/A02, February 2017

Single receiver, with illustrations for headset/bodypack and handheld configurations.

XS Wireless 1 DUAL illustrated quick guide

Multilingual with English · 2 pages · 578659/A01, October 2017

Use for the XSW 1-835 Dual-A. The guide also illustrates the 825 DUAL system.

A-band frequency table

Multilingual with English · 2 pages · 571317/A02, February 2017

Preset banks and channels specifically for the 548–572 MHz A range.

PAC setup help

Identify your receiver

The ME3-A pairs a headset with a bodypack. The 825-A uses a single e825 handheld. The 835 Dual-A has two e835 handhelds and a two-channel receiver. Use the corresponding receiver diagram to find the buttons for the channel you are setting up.

Dual receiver controls, page 25

Find a free frequency

With your transmitters switched off, hold SET/SCAN on the receiver for about three seconds. When it finds an open channel, press SET/SCAN again to save it. Scan at the venue where you will use the system.

Auto Scan for the single receiver, page 19

Sync after changing the channel

First check that the receiver and transmitter have the same frequency range. Hold SYNC on the transmitter until its LED alternates red and green. While it flashes, briefly press SYNC on the receiver for the channel you are pairing.

Sennheiser’s illustrated synchronization steps

Shop options