CAD Audio GXLIEM & GXLIEM2 In-Ear Monitor User Guide

CAD Audio · In-ear monitoring

Start with the number of monitor mixes you need. The GXLIEM sends one mix. The GXLIEM2 sends two separate mixes, so two performers can hear different balances from the console.

CAD GXLIEM single-mix transmitter, bodypack receiver, earbuds and included accessories
GXLIEM single-mix system shown.

Official manufacturer documents

GXLIEM Wireless In-Ear Monitor System manual and quick start-up guide

English · 4 PDF pages with facing booklet pages · Part 62278-04-00, September 2020

System setup, ScanLink pairing, transmitter audio inputs, bodypack controls and a T-band channel table.

PAC setup help

Feed the performer’s monitor mix

Connect a mixer monitor send to the quarter-inch audio input on the back of the base station. On the dual-mix station, use separate mixer sends if each performer needs a different mix. The front headphone jack monitors the signal at the transmitter.

Transmitter diagrams, PDF page 4

Pair the correct bodypack

Select the intended channel on the transmitter. Press its up and down buttons together for one second to start ScanLink. Aim the receiver’s infrared interface at the flashing indicator to transfer that channel. For the dual system, pair each bodypack with its intended mix.

ScanLink instructions, PDF page 3

Check the receiver before raising the level

Use the bodypack’s RF indicator to check reception. Plug the earpieces into its earphone jack, start with the volume low and raise it only enough to hear the mix. For a missing instrument, check the mixer’s monitor send before increasing the bodypack volume.

Receiver controls, PDF page 3

Shop options